ESP8266 mit NodeMcu
Aus BraLUG-Wiki
(Unterschied zwischen Versionen)
(→Firmware) |
|||
| Zeile 10: | Zeile 10: | ||
<pre> | <pre> | ||
| + | # ESP8266-01 | ||
esptool.py --port <USB-port-with-ESP8266> write_flash 0x00000 <nodemcu-firmware>.bin | esptool.py --port <USB-port-with-ESP8266> write_flash 0x00000 <nodemcu-firmware>.bin | ||
| + | |||
| + | # ESP8266-12E | ||
| + | ./esptool.py --port /dev/ttyUSB0 erase_flash | ||
| + | ./esptool.py --port /dev/ttyUSB0 write_flash -fm dio -fs 32m 0x00000 <nodemcu-firmware>.bin 0x3fc000 esp_init_data_default.bin | ||
</pre> | </pre> | ||
| + | |||
| + | (esp_init_data_default.bin siehe [https://nodemcu.readthedocs.io/en/dev/en/flash/#upgrading-firmware hier]) | ||
=Toolchain= | =Toolchain= | ||
Version vom 20. September 2016, 17:56 Uhr
Inhaltsverzeichnis |
Was soll das hier?
...
Hardware
...
Firmware
# ESP8266-01 esptool.py --port <USB-port-with-ESP8266> write_flash 0x00000 <nodemcu-firmware>.bin # ESP8266-12E ./esptool.py --port /dev/ttyUSB0 erase_flash ./esptool.py --port /dev/ttyUSB0 write_flash -fm dio -fs 32m 0x00000 <nodemcu-firmware>.bin 0x3fc000 esp_init_data_default.bin
(esp_init_data_default.bin siehe hier)
