MaD: dmesg-Ausgabe

2007-06-13T09:06:05Z

dmesg-Ausgabe

Neue Seite

[[Kategorie:Hardware]]

<pre>
Linux version 2.6.18-4-parisc (Debian 2.6.18.dfsg.1-12) (waldi@debian.org) (gcc version 4.1.2 20061115 (prerelease) (Debian 4.1.1-21)) #1 Mon Mar 26 04:55:33 MDT 2007
FP[0] enabled: Rev 3 Model 0
The 32-bit Kernel has started...
Initialized PDC Console for debugging.
Determining PDC firmware type: Snake.
model 00002000 00000481 00000000 00000000 77604171 000011f4 00000004 0000000d 00000000
vers 00000002
model 9000/720
Total Memory: 160 MB
initrd: 19b57000-19fee000
initrd: reserving 09b57000-09fee000 (mem_max 0a000000)
On node 0 totalpages: 40960
DMA zone: 40960 pages, LIFO batch:7
Built 1 zonelists. Total pages: 40960
Kernel command line: root=/dev/sdb6 HOME=/ console=tty0 sti=1 sti_font=VGA8x16 TERM=linux palo_kernel=5/vmlinux-2.6.18-4-parisc
PID hash table entries: 1024 (order: 10, 4096 bytes)
Error reading tod clock
start_kernel(): bug: interrupts were enabled early
Console: colour dummy device 160x64
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 163840k available
Calibrating delay loop... 49.40 BogoMIPS (lpj=98816)
Security Framework v1.0.0 initialized
SELinux: Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
checking if image is initramfs...it isn't (bad gzip magic numbers); looks like an initrd
Freeing initrd memory: 4700k freed
NET: Registered protocol family 16
EISA bus registered
Searching for devices...
Found devices:
1. Coral SGC Graphics at 0xf8000000 [1] { 10, 0x0, 0x004, 0x00077 }
2. Cobra Core BA at 0xf082f000 [2] { 11, 0x0, 0x004, 0x00070 }
3. Cobra Core SCSI at 0xf0825000 [2/0/1] { 10, 0x0, 0x004, 0x00071 }
4. Cobra Core LAN (802.3) at 0xf0826000 [2/0/2] { 10, 0x0, 0x004, 0x00072 }
5. Cobra Core HIL at 0xf0821000 [2/0/3] { 10, 0x0, 0x004, 0x00073 }
6. Cobra Core RS-232 at 0xf0823000 [2/0/4] { 10, 0x0, 0x004, 0x00075 }
7. Cobra Core RS-232 at 0xf0822000 [2/0/5] { 10, 0x0, 0x004, 0x00075 }
8. Cobra Core Centronics at 0xf0824000 [2/0/6] { 10, 0x0, 0x004, 0x00074 }
9. Cobra (720) at 0xfffbe000 [8] { 0, 0x0, 0x200, 0x00004 }
10. Memory at 0xfffbf000 [9] { 1, 0x0, 0x013, 0x00009 }
Enabling regular chassis codes support v0.05
CPU(s): 1 x PA7000 (PCX-S) at 50.000000 MHz
Whole cache flush 127882 cycles, flushing 3530752 bytes 405328 cycles
Setting cache flush threshold to 560 (1 CPUs online)
Asp version 1 at 0xf082f000 found.
LED (ASP-style) display at f0800020 registered
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
TCP established hash table entries: 8192 (order: 3, 32768 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 8192 bind 4096)
TCP reno registered
Chassis warnings not supported.
unwind_init: start = 0x1034acc0, end = 0x1036f7b0, entries = 9391
audit: initializing netlink socket (disabled)
audit(0.684:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
PDC Stable Storage facility v0.30
Soft power switch support not available.
STI GSC/PCI core graphics driver Version 0.9a
id 26d1482a-40a00499, conforms to spec rev. 8.02
graphics card name: HPA1659A
sticon: Initializing STI text console.
Console: switching to colour STI console 160x64
Console: switching to colour frame buffer device 160x64
fb0: stifb 1280x1024-8 frame buffer device, HPA1659A, id: 26d1482a, mmio: 0xf8100000
Generic RTC Driver v1.07
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
2:0:4: ttyS0 at MMIO 0xf0823800 (irq = 20) is a 16550A
2:0:5: ttyS1 at MMIO 0xf0822800 (irq = 21) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
mice: PS/2 mouse device common for all mice
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RAMDISK: cramfs filesystem found at block 0
RAMDISK: Loading 4700KiB [1 disk] into ram disk... done.
VFS: Mounted root (cramfs filesystem) readonly.
Freeing unused kernel memory: 328k freed
SCSI subsystem initialized
53c700: Version 2.8 By James.Bottomley@HansenPartnership.com
scsi0: 53c700 rev 0
scsi0 : LASI SCSI 53c700
Vendor: QUANTUM Model: FIREBALL_TM2110S Rev: 300N
Type: Direct-Access ANSI SCSI revision: 02
Vendor: SEAGATE Model: ST52160N Rev: 0285
Type: Direct-Access ANSI SCSI revision: 02
scsi 0:0:4:0: Attached scsi generic sg0 type 0
scsi 0:0:6:0: Attached scsi generic sg1 type 0
sd 0:0:4:0: Enabling Tag Command Queuing
SCSI device sda: 4124736 512-byte hdwr sectors (2112 MB)
sda: Write Protect is off
sda: Mode Sense: a3 00 00 08
SCSI device sda: drive cache: write back
SCSI device sda: 4124736 512-byte hdwr sectors (2112 MB)
sda: Write Protect is off
sda: Mode Sense: a3 00 00 08
SCSI device sda: drive cache: write back
sda: unknown partition table
sd 0:0:4:0: Attached scsi disk sda
SCSI device sdb: 4238282 512-byte hdwr sectors (2170 MB)
sdb: Write Protect is off
sdb: Mode Sense: 87 00 10 08
SCSI device sdb: drive cache: write back w/ FUA
SCSI device sdb: 4238282 512-byte hdwr sectors (2170 MB)
sdb: Write Protect is off
sdb: Mode Sense: 87 00 10 08
SCSI device sdb: drive cache: write back w/ FUA
sdb: sdb1 sdb2 < sdb5 sdb6 sdb7 >
sd 0:0:6:0: Attached scsi disk sdb
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Adding 128480k swap on /dev/sdb7. Priority:-1 extents:1 across:128480k
EXT3 FS on sdb6, internal journal
LASI 82596 driver - Revision: 1.30
Found i82596 at 0xf0826000, IRQ 17
drivers/net/lasi_82596.c: MAC of HP700 LAN read from EEPROM
eth0: 82596 at 0xf0826000, 08 00 09 17 DA A2 IRQ 17.
HP SDC: HP SDC at 0xf0821000, IRQ 18 (NMI IRQ 19)
HP SDC: New style SDC
HP SDC: Revision: 1820-4784
HP SDC: TI SN76494 beeper present
HP SDC: OKI MSM-58321 BBRTC present
HP SDC: Spunking the self test register to force PUP on next firmware reset.
HP SDC MLC: Registering the System Domain Controller's HIL MLC.
HIL KEYB: HIL keyboard found (did = 0xcf, lang = german)
input: HIL keyboard as /class/input/input0
input: HIL keyboard, ID: 207
hil_kbd: probe of serio1 failed with error -5
hil_kbd: probe of serio2 failed with error -5
hil_kbd: probe of serio3 failed with error -5
hil_kbd: probe of serio4 failed with error -5
hil_kbd: probe of serio5 failed with error -5
hil_kbd: probe of serio6 failed with error -5
hil_kbd: probe of serio7 failed with error -5
hil_kbd: probe of serio8 failed with error -5
hil_kbd: probe of serio9 failed with error -5
hil_kbd: probe of serio10 failed with error -5
hil_kbd: probe of serio11 failed with error -5
hil_kbd: probe of serio12 failed with error -5
hil_kbd: probe of serio13 failed with error -5
hil_kbd: probe of serio14 failed with error -5
hil_kbd: probe of serio15 failed with error -5
HP i8042 SDC + MSM-58321 RTC support loaded (RTC v 1.10d)
hil_kbd: probe of serio1 failed with error -5
serio: device_attach() failed for (), error: -5
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised: dm-devel@redhat.com
kjournald starting. Commit interval 5 seconds
EXT3 FS on sdb5, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
eth0: link ok.
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
eth0: no IPv6 routers present
process `syslogd' is using obsolete setsockopt SO_BSDCOMPAT
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
NFSD: starting 90-second grace period
HIL PTR: HIL pointer device found (did: 0x68, axis: relative)
HIL PTR: HIL pointer has 3 buttons and 1 sets of 2 axes
input: HIL pointer device as /class/input/input1
input: HIL pointer device (HIL mouse), ID: 104
</pre>

Linux auf einer HP9000-720/dmesg-2.6.18-4-parisc - Versionsgeschichte

MaD: dmesg-Ausgabe